..::: FluoreSave :::..

Chart of typical combinations of fluorescent fittings when powered by Fluoresave Energy Saving Units.

	ALL UNITS	12AMP MODEL D12	20 AMP MODEL D20	32 AMP MODEL D32
TYPE OF FITTING	MINIMUM QTY	MAXIMUM QTY	MAXIMUM QTY	MAXIMUM QTY
Single 18 watt	16	132	224	356
Twin 18 watt	10	66	112	178
Single 36 watt	10	66	112	178
Twin 36 watt	6	33	56	89
Single 40 watt	10	60	100	160
Twin 40 watt	5	30	50	80
Single 58 watt	7	40	68	108
Twin 58 watt	3	20	34	54
Single 60 watt	7	40	66	106
Twin 60 watt	4	20	33	53
Single 70 watt	6	35	57	92
Twin70 watt	3	17	28	45
Single 100 watt	4	24	40	64
Twin 100 watt	2	12	20	32
Single 125 watt	3	20	32	52
Twin 125 watt	2	10	16	26

NOTE:
These figures are for guidance only and will vary between manufacturers and age of the lamps and fittings and the power factor of the installation. For other types of gas discharge lighting, the calculation is based on total amperage draw of the circuit.

The minimum quantities are calculated from the power drawn by the lamps and fittings at the energy saving voltage level and is rounded up to the next whole number.

The maximum figures are calculated from the powered drawn by the lamps and fittings at the mains voltage and is rounded up to the next whole number.